Filter
Top Products
Initial Setup | 15
The following sections provide initial configuration information
and instructions for connecting your Dell SonicWALL NSA 2600
appliance for initial setup.
• "Connecting the MGMT Port" on page 15
• "Applying Power to the NSA 2600" on page 15
• "NSA 2600 LED Activity" on page 15
• "Using the Setup Wizard" on page 16
Connecting the MGMT Port
1. Using the provided Ethernet cable, connect one end of the
cable to the computer you are using to manage the
Dell SonicWALL NSA appliance.
2. Connect the other end of the Ethernet cable to the MGMT
port on your Dell SonicWALL NSA appliance.
Applying Power to the NSA 2600
Connect the AC power cord from the Dell SonicWALL NSA
appliance into an appropriate power outlet.
For further information regarding power requirements, refer to
"Product Safety and Regulatory Information" on page 51 of this
document.
NSA 2600 LED Activity
The Power LEDs on the front panel illuminate blue when the
appliance is powered on.
The Test LED or Alarm LED may illuminate and blink while the
appliance performs a series of diagnostic tests. When these
LEDs are no longer illuminated and the Power LEDs remain
steadily lit, the Dell SonicWALL NSA 2600 appliance is ready
for configuration. This typically occurs within a few minutes of
turning on the power.
If the Test or Alarm LEDs remain lit after the NSA 2600 has
completed powering on, restart the appliance by disconnecting
the power, waiting 1 minute, then connecting the power again.
For a connected MGMT or X0 - X7 port, the Link LED for the
port illuminates green or amber depending on the link
throughput speed, indicating an active connection:
• Amber indicates 1 Gbps
• Green indicates 100 Mbps
• An unlit left LED with the right LED lit indicates 10 Mbps