Filter
Top Products
37
T
T
ROUBLE
ROUBLE
S
S
HOOTING
HOOTING
PROBLEM CAUSE SOLUTION
Stove Will Not Start
(cont….)
4. Air Inlet Damper setting *Check for proper setting. Too much air or not
enough air will effect starting time.
*Check for blockage in the air intake connector
and fresh air intake.
5. Excessive negative
pressure in the room
*Balance pressure in the room by opening a
window.
*Turn off fan forced exhaust systems.
6. Clogged exhaust fan
or exhaust system
*Inspect and clean venting.
*inspect, remove and clean exhaust fan.
*Check air passage below and behind the burn
grate area.
7. Defective exhaust fan *Check for operation of the exhaust blower.
Turn off the heating fan, listen for hum next to
the exhaust side of the appliance.
Fuel feeds into the burn
grate but will not start.
Burn grate fills with fuel
and then shuts down.
1. Burn Grate is not installed
or seated properly.
*The auto igniter will only start wood pellets,
corn and grain have to high a moisture content.
*Ensure both parts of the grate are installed
and seated properly.
2. Burn Grate is clogged. *Remove and inspect burn grate. Remove all
ash and clinkers.
*Ensure air holes are free of debris or build-up.
3. Igniter is not glowing *Remove burn grate, close door, and re-start
the appliance. If the igniter does not glow red
inside the tube it is defective.
*Remove back panel and confirm wire
connections and condition of wires.
*If igniter is defective, the stove can be started
manually. See manual lighting instructions.
4.Air Inlet Damper setting, if
igniter is glowing and burn
grate is seated properly.
*Check for proper setting. Too much air or not
enough air will effect starting time.
*Check for blockage in the air intake connector
and fresh air intake.
Unit starts, fuel feeds
and starts properly, but
no heat output
1. Control Board *Ensure Feed Rate is set to a higher level,
*Turn Heating Fan speed down.
*Confirm mode of operation.
2.. Air Inlet Damper setting *Check the setting of the air damper. It may
have be accidently closed or opened all the
way.
*Follow “Fine Tuning” procedure in this manual.
3. Fuel *Check on quality or amount of fines found in
the fuel and hopper.
*Check the moisture content.
*Try different brand or different batch.
4. Room or Home *Check air flow patterns, amount of insulation,
Location, size of room, ceiling heights and
obstructions.
Glow Boy Pellet & Biomass www.glowboystoves.com 37