Filter
Top Products
INSTALLATION AND OPERATION MANUAL
MF3500G, MF3500S, MF3500B Models
Page 5800-345-6007
CumberlandStoveWorks.com
Overtemp Reset Hole in Back Panel
AUTOMATIC SAFETY FEATURES
POWER OUTAGE
During a power outage, the stove will shutdown safely. It
will not automatically restart when the power returns. If the
stove is still above the proper operating temperature, the
room fan will circulate the remaining heat in the stove. See
Lighting Instructions.
OVERHEATING
Over Fire Protection: If the stove is being over fired or
burning too hot, a high temperature switch will automatically
shutdown to avoid damage to components. Allow stove to
cool at least one hour before relighting. Reset overtemp
button and relight stove. See Lighting Instructions for
complete instructions.
CAUTION
Installation and repair of this parlor stove should be
done by a qualified service person. The appliance
should be inspected before use and at least annually
by a qualified service person. It is imperative that
control compartments, burners, and circulating air
passageways of the stove be kept clean.
The operation of exhaust fans such as bathroom
fans, attic fans, etc. might starve the parlor stove
of combustible air creating a negative pressure in
the room. Provide adequate ventilation of the room
accompanying the parlor stove. If not, the pressure
switch may shut off operation of the parlor stove.
The moving parts of this stove are propelled by
high torque electric motors. These parts can cause
severe damage to body parts that get near them.
Keep all body parts away from auger and fans while
the stove is plugged into an electrical outlet. These
moving parts may begin to move at any time the
stove is plugged in.
If the electrical power fails any time when the stove
is hot, keep the door closed at all times to prevent
harmful gases from entering the room.
Vent surfaces can get hot enough to cause burns
if touched by children. Noncombustible shielding or
guards may be required.
Install vent at clearances specified by the vent
manufacturer.
All venting, whether vertical or horizontal, joints
should be made gas tight with recommended
sealants.
According to HUD (Housing & Urban Development)
requirements, when installed in a mobile home, this
stove must be grounded directly to the steel chassis
of the mobile home and bolted to the floor. Direct
air access must be provided, use a Fresh Air Kit.
For use in the United States. Suitable for installation
in mobile homes.
Cumberland Stove Works, manufacturer of this
appliance, reserves the right to alter its products,
specifications and/or price without notice.
WARNING
IF THE ELECTRICAL POWER FAILS ANY TIME WHEN
THE STOVE IS HOT, KEEP THE DOOR CLOSED AT
ALL TIMES TO PREVENT HARMFUL GASES FROM
ENTERING THE ROOM.
THESE AUTOMATIC SAFETY FEATURES MUST NOT BE
BYPASSED.