Filter
Top Products
21
START-UP REPORT
FOR SUBMERSIBLE PUMPS
This form is designed to provide assurance that customer service and a quality product are the number one priority with
Crane Pumps & Systems, Inc (CP&S). Please fi ll out the following questions as completely and accurate as possible.
When complete, mail this form to:
In U.S.A Send To: In Canada Send To:
Crane Pumps & Systems, Inc Crane Pumps & Systems, Inc.
Attn: Warranty Service Group Attn: Service Manager
420 Third Street 83 West Drive, Brampton
Piqua, Ohio 45356 Ontario, Canada L6T 2J6
REPORTS THAT ARE NOT RETURNED CAN DELAY OR VOID WARRANTY.
Pump Owner’s Name:
Address:
Location of Installation
Person in Charge Phone
Purchased From (Crane Pumps & Systems Representative/Distributor
Pump Model Serial No.
Part Number
Voltage Phase Hertz Horespower
Rotation: Direction of impeller rotation (Use C/W for clockwise, CC/W for counter-clockwise)
Method used to check rotation (viewed from bottom)
Does impeller turn freely by hand: Yes No
Condition of equipment Good Fair Poor
Condition of cable jacket Good Fair Poor
Resistance of cable jacket Good Fair Poor
Resistance of cable and pump motor (measured at pump control)
Red-Black Ohms, Red-White Ohms, White-Black Ohms
Resistance of Ground Circuit between Control Panel and outside of pump Ohms
MEG Ohms check of insulation:
Red to Ground White to Ground Black to Ground
Condition of equipment at Start-Up: Dry Wet Muddy
Was Equipment Stored? Length of Storage
Describe station layout
Liquid being pumped
Debris in bottom of station?
Was debris removed in your presence?
Are guide rails exactly vertical?
Is BAF stationary installed level?
Liquid level controls: Model
Are level controls installed away from turbulence?
Operation Check:
Tip lowest fl oat (Stop Float), All pumps should remain off.
Tip second fl oat (and Stop Float), one pump comes On.
Tip third fl oat (and Stop Float), both pumps on (alarm on simplex).
Tip fourth fl oat (and Stop Float), high level alarm on (omit on simplex).
If not CP&S level controls, describe type of controls
Does liquid level ever drop below volute top?