Filter
Top Products
BOTTOM VALVE CONCEALER KIT - BVCK5/10
NOTE: This kit has been designed and cel_ified for use with aCozy gas baseboard heater only. Use only factory
supplied kit and components.
STEP 1. Place the mounting plate against the wall and flush with the bottom of the gas baseboard heater.
The mounting plate must cover the manual gas shut offvalve. See Figure 1. Mark the location of
the mounting holes.
STEP 2. Drill holes where marked. Depending on wall material, install anchors (not provided) if needed.
STEP 3. Secure mounting plate to wall with screws (not provided).
STEP 4. Attach the cover to the mounting plate by lining up the two catches inside the cover with catches
on mounting plate. Push cover toward wall until catches snap into place. See Figure 2.
STEP 5. For access to the manual gas shut-offvalve, grasp the cover on both sides and pull out until the
snap catches release.
Manual gas shut
off valve must have
rout off above floor
j_._ Mounting Plate
4-1/4" Above floor
Mounting
Holes (4)
FIGURE 1
COZY Ga]_%
Baseboard !
Heater
Manual gas shut
off valve must have
cut off above floor
WYapper
p,
Wrapper catches _ _ ,,
i i _' 4-1/4 Above floor
FloorJ
FIGURE 2
Page 18