Filter
Top Products
VENT RISER KIT
VRK5/10
NOTE: This kit has been designed and certified for use
with a Cozy gas baseboard heater only. Use only factory
supplied kit and components.
WARNING: DO NOT INSTALL IN WINDOW WELL
OR BELOW GRADE WHERE WATER MAY
ACCUWIULATE. MUSTNOT TOUCH THE GROUND!
STEP1.
STEP2.
STEP3.
STEP4.
STEP5.
STEP6.
Install Cozy gas baseboard heater per
installation instructions.
Check that the air intake pipe extends
1-1/2" past the outside wall and the vent
exhaust tube extends 2-1/2" past outside
wall. See Figure 1.
Place the mounting plate over the air
intake tube and slide back flush against
wall. Markthe locationofthe six
mounting holes on wall. See Figure 2.
Drill the six mounting holes. Depending on
wall material, install anchors (not
provided) if needed.
Secure mounting plate to wall with screws
(not provided).
Place the vent riser kit over the vent
exhaust tube, slide back into position and
secure to mounting plate with screws
provided. See Figure 3.
MOUNTING
PLATE_
AIR
MOUNTING
HOLES
VENT EXHAUST
TUBE
FIGURE 2
J
I
VENT RISER KIT
INSTALLED
FIGURE 3
1-t2"
AIR INTAKE
VENT
EXHAUST
TUBE
FIGURE 1
Page 16