Filter
Top Products
SIDE VALVE CONCEALER KIT- SVCK5/10
NOTE: This kit has been designed and certified for use with a Cozy gas baseboard heater only. Use only factory
supplied kit and components.
STEP1.
STEP2.
STEP3.
STEP4.
STEP5.
With the offset up and out from the wall, place the mounting bracket flush to the fight side of the
heater cabinet. Align the top of the mounting plate with the top of heater cabinet. Mark the
location of the mounting holes. See Figure 1.
Drill holes where marked. Depending on wall material, install wall anchors (nor provided) if
needed.
Secure mounting plate to wall with screws (not provided).
Attach the cover to the mounting plate by placing the cover top edge over the offset on the
mounting plate. Push the cover in toward wall until catch snaps into place. See Figure 2.
For access to the manual gas shut offvalve, locate finger handle at the bottom of the cover. Pull
out until snap catch releases then lift cover up to remove from mounting plate. See Figure 2.
cozY '-,.
Baseboard
Heater
_'-_'f;et must be out
fromwalt
'_ Mounting
Holes (4)
Mountin2
Plate
Manual gas shut
off valve
FIGURE 1
...............................................................
Heater ! ...........
L_A
Cover
._r_ Cabinet
catch
Manual gas
shut off valve
Finger
handle
FIGURE 2
Page 17