Filter
Top Products
496679 17
The system carries on to set as normal. The system will not raise an
alarm if the omitted zone is triggered.
Note: The next time you set the system the zone will operate as normal; omission
only lasts for one setting/unsetting cycle.
Omitting 24 Hour Detector Zones
If your system is fitted with 24 Hour Detector Zones, you may be able to omit
them if necessary. For example, your premises may have a fire door pro-
tected by a 24 Hour zone that you occasionally open. Ask your Installer if this
is possible.
If your system is programmed to allow you to omit a 24 hour zone, then:
1. Key in your access code and press .
The display shows:
2. Press the number of the
zone you want to omit (for example, key
in 7 to omit zone 7) and then press .
The sounder gives a double beep and
the display shows the zone number
followed by an "o":
To reinstate a 24 hour zone:
1. Key in your access code.
2. Press followed by the zone number and then .
Note: When you set the system again the control unit will re-instate any 24 hour zone
you have omitted.
Access Codes
The system can store up to 16 different user access codes. For security you
should give one code to each person who has responsibility for setting and
unsetting the system. Do not allow users to share codes.
Every time someone enters an access code on the keypad the system
records the event in its log. To distinguish all the users and keep their access
codes hidden, the log shows each user as a number, for example "User 02",
"User 03" and so on.
When delivered from the factory all access codes are set to default numbers.
User 01 default access code is "1234". You should change this immediately
to a code that only you know. User 01 is the only access code that can
change other access codes.
"beep beep"
4. Special Functions