Filter
Top Products
10 496679
Setting From a 725r
If your system is fitted with a radio expander and your installer has enabled
the appropriate option, you can use a 725r telecommand to set the system.
To full set the system:
1. Close all doors and windows.
2. Press .
3. Leave the premises and close the final door.
The system completes the programmed exit mode, gives a double "beep",
and sets.
To part set the system.
1. Close all doors and windows.
2. Press .
The system completes the programmed exit mode, gives a double "beep",
and part sets in Level B.
If the System Will Not Set
Detector Active
If you try to set the system while something is triggering one of the detectors
in the protected area (for example a door or window is still open) then the
keypads or internal sounder will give an interrupted tone and the display will
show the zone number of the detector.
1. Go to the zone shown on the display and find out what is triggering the
detector. If possible remedy the fault.
2. Return to the keypad and set the system again.
If no other detectors are active the system sets.
3. Repeat steps 1 to 3 if the display shows other zones.
4. If you still cannot set the system then call the Installer.
Other Faults
If the control unit detects certain kinds of technical fault it lights the lamp
on the keypad to warn you that there is a problem. Some problems are
temporary and the control unit may allow you to carry on and set the system.
For example, if the mains supply is interrupted then on the keypad glows
and the lamp flashes. When you come to set the system the keypad
display shows the words:
2. Everyday Operation