Filter
Top Products
CONAIR
05-15-96 79 35
11.1.3 79, Hopper with band conveyor
Disassembling/Assembling the band conveyor
Disassembling
1. Release the fastening screw (A). This
is done most easily by unscrewing the
nut on the under side. The vibration
absorber is then released.
2. Release the hood over the screw (B)
and remove the screw.
3. Pull the worm-gear unit motor off the
shaft.
4. Release the shaft gears by unscrewing
the two screws (C) on each side of the hopper funnel.
5. Loosen the band conveyor's height
setting by unscrewing the screw which
fastens the height setting by the guide
pin (D).
6. Release the shaft gears and move the
band conveyor to the right so that the
left shaft goes free from the hub. Turn
the band conveyor to the right until the
shaft end goes free from the hopper
funnel.
Move the band conveyor to the left
until the motor shaft end goes free
from the hopper funnel. The band
conveyor can then be released.
A
B
C
D