Filter
Top Products
CONAIR
05-15-96 79 13
Assembling the rotating knives
1. Clean the cutter's knife location and place a rotating knife in the knife
location.
2. Fasten the screws (A) together with the washers (H) and tighten gently.
3. Adjust the knife using the setting
screws (B) to give the correct
amount of play, 0.15-0.30 mm
between the fixed and rotating
knives. Check using the feeler
gauge included in the tool kit.
4. When the correct amount of play
has been obtained, tighten the
screws (A) with a torque of 200
Nm.
5. Tighten the counter nut.
6. Re-check the amount of play.
Assembling the upper fixed knife
7. Push the upper fixed knife into its
groove.
8. Turn the cutter so that the rotating
knife's cutting edge comes exactly
in front of the upper fixed knife's
cutting edge.
9. Adjust the fixed knife using the
setting screws (D) and (F). By
tightening screws (F) the knife is
moved towards the cutter's centre.
By tightening screws (D) the knife
is moved away from the cutter's
centre.
10. Tighten the 5 screws (E) along the
upper long side, and the two that were loosened on one short side.
11. Check that screws (D) and (F) by the upper fixed knife are not loose.
However, they should not be tightened too much.
12. Rotate the rotor and replace the other rotating knives according to steps 1 -
5 above.
13. Using a feeler gauge, check that the distance between the fixed and rotating
knives is correct. The distance should not be less than 0.15 mm.
Granulator fitted with a third fixed knife:
See instructions in chapter 11.