Filter
Top Products
CONAIR
05-15-96 79 33
11.1.1 79, all models: Third fixed knife, disassembling/
assembling
Pos. Qty. Part no.
1 1 1-19022
2 1 2-17732
3 1 2-17733
4 2 9-40106
5 2 9-40302
6 1 3-19021
7 2 9-40075
8a 2 9-50086
8b 2 9-50214
9 2 9-40050
Disassembling
1. Unscrew the screws (4) and release the ruler (3).
2. Lift out the knife (6).
Assembling
1. Clean any grease or plastic waste from the knife location.
2. Position the fixed knife (6) with the adjusting screw (5) and press against the
rear edge.
3. Adjust to obtain the correct amount of play between the fixed and rotating
knife using the adjusting screws (5).
4. Using a feeler gauge, check that the correct amount of play, 0.15 - 0.30 mm,
has been obtained.
5. When the amount of play is correct, place the ruler (3) with the screws (4)
on the knife and tighten with a torque of 100 Nm.