Filter
Top Products
Installation Instructions CM2L40
17
Extended Programming Capabilities
The CM2 allows for extended programming to make the mount
compatible with other devices such as a Universal Remote or
other control devices through a serial connection.
Setting or changing the configuration of the CM2 is done
through the remote control provided with the mount.
The remote control has a range of 20-30 ft (6-9m), and is
powered by 2 AAA batteries that are accessed from the back of
the remote.
NOTE: If operation of the mount is required at a greater
distance than remote control will allow, the mount can
be controlled through a hardwired switch or similar
device. See Dry Contact Closures section and (See
Figure 32) .
The following table and illustration identify mount functionality
and response by button on the remote control.
Normal Operating Mode
Figure 29
1
2
3
4
5
6
7
8
9
10
11
12
13
KEY FUNCTION REQUIRED ACTION
1 NOT USED N/A
2 NOT USED N/A
3 RAISE DISPLAY PRESS
4 NOT USED N/A
5 STOP PRESS
6 NOT USED N/A
7 LOWER DISPLAY PRESS
8 NOT USED N/A
9 NOT USED N/A
10 NOT USED N/A
11 NOT USED N/A
12 NOT USED N/A
13 NOT USED N/A