Filter
Top Products
Installation Instructions CM2L40
13
Figure 20
7. Route cables under cable pulley and up over top of cable
pulley. (See Figure 19) and (See Figure 20)
8. Route one cable from front (black) cable clamps through the
#2 cable opening and straight down next to the cable pulley
center shaft.
(See Figure 19) and (See Figure 20)
9. Route one cable from front (black) cable clamps through the #3
cable opening and straight down next to the other side of the
cable pulley center shaft. (See Figure 19) and (See Figure 20)
10. Route one cable from rear (gray) cable clamps through the
#2 cable opening and straight down next to the cable pulley
center shaft.
(See Figure 19) and (See Figure 20)
11. Route one cable from rear (gray) cable clamps through the #3
cable opening and straight down next to the other side of the
cable pulley center shaft. (See Figure 19) and (See Figure 20)
IMPORTANT ! : Ensure that cables are not twisted! Cables
from front (black) of upper cable clamp (See Figure 19) must be
on front of cable pulley (See Figure 20) and front of lower cable
clamp (See Figure 19). Cables from rear (gray) of upper cable
clamp (See Figure 19) must be on rear of cable pulley (See
Figure 20) and rear of lower cable clamp (See Figure 19).
12. Continue routing cable(s) down through lower cable
clamps. (See Figure 19)
13. Tighten upper cable clamp making certain cables are
properly seated in clamp and are not pinched.
CAUTION: OVERTIGHTENING OF CABLE CLAMPS CAN
CRUSH CABLES LEADING TO DAMAGE TO EQUIPMENT!
DO NOT over tighten cable clamps.
14. Starting at upper cable clamp and working downward,
remove slack from all cables and tighten lower cable
clamps. (See Figure 19)
15. Slide cable guide side cover over CM2 mount lining up two
holes in cable guide side cover with two holes in CM2
mount. (See Figure 21)
Figure 21
16. Secure cable guide side cover to CM2 mount using two
screws (removed in Step 1). (See Figure 22)
Figure 22
8
6
9
8
7
9
Cable
pulley
center
shaft
10
11
Cable guide
side cover
15
x 2
16