Filter
Top Products
3
An unbalanced garage door might not reverse when
required and someone under the door could be seriously
injured or killed.
If your garage door binds, sticks or is out of balance, call
for professional garage door service. Garage doors, door
springs, cables, pulleys, brackets, and their hardware are
under extreme tension and can cause serious injury or
death. Do not try to loosen, move or adjust them
yourself!
Ropes left on a garage door could cause someone to
become entangled and killed. Remove all ropes
connected to the door before installing and operating the
opener.
To avoid damage to the garage door and opener, disable
locks before installing and operating the opener. Use a
wood screw or nail to hold locks in the "open" (unlocked)
position.
Operation at other than 120V 60 Hz will cause opener
malfunction and damage.
Safety Reversing Sensor
Installation
Lag Screw 1/4 x 1-1/2" (4)
Hex Screw 1/4-20 x 1-1/2" (2)
Carriage Bolts 1/4" - 20 x 1/2" (4)
Screw #10 - 32 x 3/8" (4)
Lock Nut 1/4" - 20 (4)
Lock Nut #10 x 32 (4)
Wing Nut (2)
Insulated Staples (20)
Rail Assembly
Coupling Sleeve (1)
Hex Screw 1/4"-20 x 5/8" (4)
Nut 1/4" - 20 (4)
Identify the type and height of your door, any special
conditions that exist, and any additional materials that
may be required.
Test Your Door for Balance
Before you begin, complete the following test to make
sure your door is balanced, and is not sticking or
binding:
• Lift the door about halfway as shown. Release the door.
It should stay in place, supported entirely by its springs.
• Raise and lower the door to see if there is any binding or
sticking.
WARNING
CAUTION
WARNING
WARNING
CAUTION
CAUTION
WARNING
SECTIONAL DOOR
ONE-PIECE DOOR
Hardware Supplied
Sectional
Door
One-Piece
Door
Safety Information and Precautions
LIGHT
LOCK
1 2
3 4
5 6
7 8
9 0
ENTER
Model 84LM
Model 742LM
Model 64LM
Model 99LM
Model 59LM
Model 66LM
Multi-Function Mini Remote
Control:
With key ring & Velcro fastening
strip.
Keyless Entry:
Enables homeowner to operate garage
door opener from outside by entering
code on specially designed keyboard.
Outside Keylock:
Operates the garage door
automatically from outside when
remote control is not handy.
Plug-In Light Control:
Controls interior lights. Plugs into a
wall receptacle.
Outside Quick Release:
Required for a garage with NO access
door. Enables homeowner to open
garage door manually from outside by
disengaging trolley.
8 foot Complete Rail:
To allow an 8 foot door to open fully.
Remote Security Transmitter:
Enables homeowner to operate garage
door opener by entering 2, 3, 4, or 5
digit code from backlit keyboard.
Includes visor clip.
Model 61LM
Single-Function Standard Size
Remote Control:
Includes visor clip.
Model 82LM
2-Channel “Smart” Remote Control:
Includes visor clip.
Model 81LM
“Smart” Remote Control:
Includes visor clip.
Model 83LM
3-Channel “Smart” Remote Control:
Includes visor clip.
4-Channel “Smart” Remote Control:
Includes visor clip.
Model 88SD
Model 722LM
Wire-In Light Control:
Controls interior or exterior lights.
Wires into the electrical box like a
dimmer switch.
34
Model 58LM
Multi-Function Door Control Panel:
Provides a Lock Feature which
prevents operation of garage door
opener from portable remotes and a
Light Feature for constant light.
Model 1702LM
Accessories Available For Your Opener
Opener Installation
Hex Screw 5/16"-18 x 7/8" (4)
Lag Screw 5/16"-9 x 1-5/8" (2)
Lag Screw 5/16"-18 x 1-7/8" (2)
Carriage Bolt 5/16"-18 x 2-1/2" (2)
Clevis Pin 5/16" x 2-3/4" (1)
Clevis Pin 5/16" x 1-1/4" (1)
Clevis Pin 5/16" x 1" (1)
Nut 5/16" - 18 (6)
Lock Washer 5/16" (6)
Screw 6AB x 1" (2)
Insulated Staples (10)
Ring Fastener (3)
Handle
Dry Wall Anchors (2)
Rope