Filter
Top Products
24
Chateau™ Decorative Gas Appliance
20009543
LG291a
attach fettle
andirons
6/05 djt
Andirons
Fettle
Burner Tubes
Burner
Housing
LG291
Fig. 42 Ensure fettle is securely attached to the burner hous-
ing and set andirons in place.
4. Place the ember material lightly, between each
burner tube assembly and the burner housing, be-
tween the joined burner tubes and in front over the
burner tube and on top of burner tube.
NOTE: The ember material must be built up from the
burner tubes to the burner housing fronts in order for
the burner tubes to light properly.
7. Position the log grate/burner tube. (Fig. 46) Hold the
log with the pointed end down and the flat surface
away from you. Slide the wider end of the log at an
angle in the third opening “middle” of the fettle. Hook
the log on the fettle and set down over the burner
tube assembly. Repeat the same procedure on the
opposite side.
5. Position the log pilot plumbing. (Fig. 44) Hold the
log with the two (2) branches facing down and set it
down over the pilot plumbing with the flat side of the
log touching the side refractory.
6. Position the log burner overlay. (Fig. 45) The overlay
is very fragile and must be handled with extra care.
Hold the overlay with the flat surface facing down.
The notched corners of the overlay should be on the
side of the pilot. Set the overlay on top of the burner
housing and align it right to left over the burner hous-
ing. Make sure the overlay fits between the two (2)
fettles.
Log Pilot
Plumbing
Pilot
LG424
Fig. 44 Position log pilot plumbing.
Burner
Overlay
LG425
Fig. 45 Position burner overlay. Notched corners are on the
pilot side.
Log Grate/
Burner Tube
LG426
Log Grate/
Burner Tube
Fig. 46 Position the log grate/burner tube.
Ember Material
Lava Rock
LG423a
Fig. 43 Lava rock and ember placement.