Filter
Top Products
AGING --
AS
C
CAP --
CH
COMP --
CN
EMI
FMC
FU
GND --
HA
HS
IDC Th --
IFM
JEM-A --
K
ODA Th --
ODC Th --
OFM --
OL
PCB
PTC
LEGEND AND NOTES FOR FIG. 22-25
For Bum-In Test (short these terminals) RA Th -- Retum Air Temperature Thermistor
Assembly RC -- Resistor Capacitor
Contactor RCV -- Receiver
Capacitor RVS -- Reversing Valve Solenoid
Crankcase Heater STM -- Steppin_g Motor
Compressor RB Terminal Block
Connector TP -- Thermal Protector
Electromagnetic Interference TRAN -- Transformer
Fan Motor Capacitor
Fuse _ Terminal (Marked)
Ground
Home Automation © Terminal (Unmarked)
Hall (Rpm) Sensor • Splice
indoor Coil Temperature Thermistor
Indoor-Fan Motor Terminal Block
Japan Electdc Manufactudng
Industry Association Factory Widng
Relay
Outdoor Air Thermistor Field Control Wiring
Outdoor Coil Thermistor
Outdoor-Fan Motor Field Power Widng
Ovedoed Accessory or Optional Wiring
Printed Circuit Board
Start Thermistor
NOTES:
1. Ifany ofthe odginal wire furnished must be replaced, it must be re-
placed with Type 90° C wire or its equivalent.
2. Wire in accordance wi_ National ElecbP.,alCode (NEC) and local codes.
3. Thermistor widng cable 35 ft long provided with unit.
4. Transformer has intemal 2A thermal fuse on the pdrnary side.
5. OFM and IFM are protected with internal thermal ovedoeds.
23