New Buck Corporation CR8T Indoor Fireplace User Manual


 
IMPORTANT SAFEGUARDS
Although your gas logs are very realistic in appearance, it is not a real burning fireplace and
must not be used for burning solid fuel.
To avoid irreparable damage to the heater or personal injury, matches, paper, garbage, or any
other material must not be placed or thrown on top of the logs or into the flames.
To avoid personal injury, do not touch hot surfaces when the heater is operating. Close
supervision is necessary when the heater is being operated near children.
WARNING: IN THE EVENT OF THE LOG BEING REMOVED, CARE SHOULD BE
TAKEN TO NOT DAMAGE THE LOGS.
THE HEATER IS INTENDED FOR USE AS A GAS HEATER MOUNTED IN A VENTED
OR VENT-FREE FIREPLACE AS DESCRIBED IN THESE INSTRUCTIONS. IT SHOULD
NOT BE USED FOR ANY OTHER PURPOSE.
CLEANING
CAUTION: BEFORE CLEANING OR MOVING LOGS OR OTHER PARTS
OF THE HEATER, BE SURE TO READ THE ABOVE SECTION ON “IMPORTANT
SAFEGUARDS”.
All cleaning should be carried out when the heater is cold. Only limited cleaning will be required
under normal use. Dusting the front of the base, the top of the piezo cover, or the control knob
panel may be required occasionally. Do not use any cleaning fluids to clean the logs or any
other part of the heater.
If the flames show any unusual shapes or behavior, or if the burners fail to ignite properly,
then the burner holes may require cleaning. If this occurs, it is preferable to contact your nearest
dealer to get your heater serviced.
Alternatively, the heater can be cleaned by removing the top, front, and rear logs. Handle the
logs gently so as not to damage them. Always lift each log by holding it carefully at each end.
Use a vacuum cleaner to carefully remove dust and loose particles from the base, logs, and from
around the burners.
WARNING: Failure to keep the primary air openings(s) of the burner(s) clean may result in
sooting and property damage.
25