Filter
Top Products
CONTINUED
9. After lighting the heater check to
ensure that the log placement is cor-
rect, and that no flame is coming in
contact with the logs. If log place-
ment is incorrect reverse steps 5 and
6, and see page 10, Figure 13.
REMOVING CAST STOVE
FRONT PANEL
If at some time you may need to remove
the front panel of your Cast Stove unit
for servicing or replacement follow these
steps.
A. Facing the front of the unit with ac-
cess door in the closed position remove
the two (2) hex screws holding bottom
front of stove in place. Screws are lo-
cated on the bottom front between the
access door and front legs. You may dis-
card the screws . (See Figure 16)
B. Remove the Center Grate located on
the top of the unit.
C. Using an Allen wrench, remove the
Alignment Stud (Allen Screw) from the
top front center of the unit.
NOTE: Be prepared to hold the Front
Panel while removing the Alignment
Stud. The panel may come out by ap-
plying pressure, and may cause damage
to the panel or cause personal injury.
D. Replace front panel and (Allen screw)
Alignment Stud before returning to nor-
mal usage.
ALIGNMENT STUD
(ALLEN SCREW)
FRONT PANEL SHIPPING SCREWS
(DISCARD)
FRONT PANEL
FIGURE 16 - FRONT OF CAST STOVE/FRONT PANEL
DOUBLE DOORS
CENTER GRATE
12