Filter
Top Products
11. Check general catch bolt
alignment with door claw. Make
final adjustment and door leveling
after stove is in normal standing
position.
12. Carefully lift stove back up on its
four attached legs.
13. Set top grate into stove top.
14. If available, install gas log heater
inside stove cavity before
installing the back panel (See
Installing Gas Log Heater Into
Stove, page 9).
15. Fasten back panel to stove with
six (6) M6 x 1—20mm bolts and
washers. Make sure product
identification label is located on
the outside in lower left hand
corner.
INSTALLATION
Continued
9. Attach stove door by inserting
step bolt through door hinge
pivot hole and into threaded hole
in stove body (See Figure 9 and
10 on page 8). Use an adjustable
wrench or a 12mm socket to
fasten step bolt. Tighten step bolt
until snug. Make sure door
moves freely.
10. Install door catch bolt (M8 x 1.25
– 55mm with two M8 hex nuts)
into threaded hole on stove body
(See Figure 10, page 8). Use an
adjustable wrench or a 12mm
socket. The catch bolt has two
hex nuts attached to it. The top
nut is a bolt stop and the bottom
nut is for door leveling
adjustment.
BOTTOM OF
STOVE UNIT
WASHERS
BOLTS
FIGURE 8 - ATTACHING STOVE LEGS
STOVE DOOR
DOOR
HINGE
STEP
BOLT
BOLT
SHOULDER
THREADED
HOLE
STOVE DOOR
DOOR
HINGE
STEP
BOLT
STOVE BOTTOM
BOLT
SHOULDER
FIGURE 9 - ATTACHING STOVE DOOR
DOOR
DOOR CLAW
BOLT STOP
ADJUSTING NUT
CATCH BOLT
FIGURE 10 - CATCH BOLT AND DOOR CLAW ORIENTATION
NOTE: IF YOUR CASTING HAS A
DROP BOTTOM– DO NOT INSTALL–
DISCARD THE BOTTOM.
8