Filter
Top Products
OPERATION
PILOT AND FLAME
Your appliance is equipped with a standing pilot to ensure proper burner ignition. It is visible
by looking over the top of the middle log 6" from the right side. While igniting, the flame
should impinge on the lighting port tube between the rear and middle burner, which ignites the
front and rear burner.
When burning, the flame on the middle log should be primarily blue, about 1" to 2" tall and
causing a glowing effect on the face of the middle log. The rear flame should be 4" to 5" above
the top of the rear log.
GLASS DOOR INSTALLATION
Install the glass door on your appliance by placing the door brackets over the studs on the
stove: three at the top and three at the bottom. Simply tighten nut on each. Do not abuse door,
i.e. drop or slam it.
When the glass door has been removed for cleaning or service, carefully store it in a safe place.
If the door should become broken use caution when removing the broken glass from the frame.
WARNING
Do not operate appliance with the glass front removed, cracked, or broken. Replacement
of the glass should be done by a licensed or qualified service person.
WARNING
Never operate your appliance with broken glass. Never replace the glass with any
material other than glass supplied by your dealer. Replace broken or damaged door/
frame assembly with a new assembly from your dealer.
When cleaning the glass, do not use abrasive type cleaners. Use only soap and water. Never
clean the glass when hot!
Figure 19
23