Filter
Top Products
BEFORE EMBROIDERING
Embroidery
147
5
c
cc
c
Insert the embroidery unit connection into
the machine connection port. Push lightly
until the unit clicks into place.
a Embroidery unit connection
b Machine connection port
c Feed dog position switch
d
dd
d
Turn the main power to ON.
→ The following message will appear.
e
ee
e
Press .
→ The carriage will move to the initialization position.
■ Removing the Embroidery Unit
a
aa
a
Press either or , then press
.
→ The carriage will move to the removal position.
b
bb
b
Turn the main power to OFF.
Note
• Be sure there is no gap between the embroi-
dery unit and the sewing machine. If there is
a gap, the embroidery patterns will not
embroider with the correct registration.
• Do not push on the carriage when installing
the embroidery unit onto the machine. Mov-
ing the carriage may damage the embroi-
dery unit.
• Be sure to set the feed dog position switch
to right to lower the feed dogs.
b
a
c
Note
• A confirmation message to lower the frame-
securing lever after the carriage moves to its
initial position.
• The message will disappear after 15 sec-
onds or press to move to the next
step.
CAUTION
• Always remove the embroidery frame before
pressing . Otherwise, the frame may
strike the embroidery foot, and possibly cause
injury.
• The embroidery unit will not fit in the storage
case if this step is not done.
Note
• Be sure to turn off the machine before
attaching the embroidery unit, otherwise
damage to the machine may result.