Filter
Top Products
SEWING
Sewing Basics
47
2
Sewing Heavyweight Fabrics
The sewing machine can sew fabrics up to 6 mm
(approx. 1/4 inch) thick. If the thickness of a seam
causes sewing to occur at an angle, help guide the
fabric by hand and sew on the downward slope.
■ If the Fabric does not Fit under the
Presser Foot
If the presser foot is in the up position, and you are
sewing heavyweight or multiple layers of fabric
which do not fit easily under the presser foot, use
the presser foot lever to raise the presser foot to its
highest position. The fabric will now fit under the
presser foot.
■ If the Fabric does not Feed
If the fabric does not feed when starting to sew or
when sewing thick seams, press the black button on
the left side of presser foot “J”.
a
Raise the presser foot.
b
While keeping the black button on the left
side of presser foot “J” pressed in, press the
“Presser Foot Lifter” button to lower the
presser foot.
c
Release the button.
→ The presser foot remains level, enabling the fabric to
be fed.
CAUTION
• Do not forcefully push fabrics more than
6 mm (approx. 1/4 inch) thick through the
sewing machine. This may cause the needle to
break and cause injury.
Memo
You cannot use the presser foot lever after the
presser foot has been raised using the
“Presser Foot Lifter” button.
Memo
• Once the trouble spot has been passed, the
foot will return to its normal position.
• When “AUTOMATIC FABRIC SENSOR
SYSTEM” (Automatic Presser Foot Pres-
sure) in the machine settings screen is set to
“ON”, the thickness of the fabric is automati-
cally detected by the internal sensor so the
fabric can be fed smoothly for best sewing
results. (See page 55 for details.)