Filter
Top Products
ERROR MESSAGES
244
This message is displayed when
the patterns you are editing take
up too much memory, or if you
are editing too many patterns for
the memory.
This message is displayed when
the embroidery unit is attached
and the power is turned on with
the needle in the down position.
This message is displayed when
the “Start/Stop” button is pushed
to sew Utility stitches or
Character/Decorative stitches
while the foot controller is
connected. (This message does
not appear when embroidering.)
This message is displayed when
the buttonhole lever is up, a
buttonhole stitch is selected, and
the “Start/ Stop” button or
“Reverse/Reinforcement Stitch”
button is pushed.
This message is displayed when
the “Start/ Stop” button is pushed
while the machine is in
embroidery edit mode and a
pattern is being edited.
This message is displayed when
there are too many characters
and the curved character
configuration is impossible.
This message is displayed when
a key on the LCD display is
touched while the needle is in
the down position.
This message is displayed when
the machine is in embroidery
mode and the combined
character pattern is too large for
the embroidery frame. You can
rotate the pattern 90 degrees
and continue combining
characters.
This message is displayed when
the buttonhole lever is down, a
stitch other than a buttonhole is
selected, and the “Start/ Stop”
button or the “Reverse/
Reinforcement Stitch” button is
pushed.
This message is displayed when
the machine is in embroidery
mode, and the character pattern
combination is too large to fit in
the embroidery frame.