Filter
Top Products
SEWING AN EMBROIDERY PATTERN
Embroidery
167
5
f
Repeat the same steps for embroidering the
remaining colors.
→ When the last color is sewn, “Finish sewing” will
appear on the display. Press , and the
display will return to the original screen.
■ When Threading Manually
a
Thread the machine manually with the first
color (see “Threading Manually” on page
31).
b
Lower the presser foot, then press the
“Start/Stop” button to start embroidering.
After 5-6 stitches, press the “Start/Stop”
button again to stop the machine.
c
Trim the excess thread at the end of the
seam. If the end of the seam is under the
presser foot, raise the presser foot, then
trim the excess thread.
d
Press the “Start/Stop” button again to
restart the machine.
e
Repeat steps d and e from the previous
section.
Memo
The Thread Trimming Function is originally set
to trim excess thread jumps (threads linking
parts of the pattern, etc.). When an end of
upper thread may remain on the surface of the
fabric at the beginning of the stitching,
depending on the type of thread and fabric
that are used. After embroidering is finished,
cut off this excess thread.
*If the setting has been turned off, trim the
excess thread jumps using scissors after the
pattern is finished.
See page 175 for information on the thread
trimming function.
Memo
If there is thread left over from the beginning
of sewing, it may be sewn over as you con-
tinue embroidering the pattern, making it very
difficult to deal with the thread after the pattern
is finished. Trim the threads at the beginning.