Filter
Top Products
ADJUSTMENTS DURING THE EMBROIDERY PROCESS
170
ADJUSTMENTS DURING THE EMBROIDERY PROCESS
If the Bobbin Runs Out of Thread
When the bobbin begins to run out of thread
during embroidering, the machine will stop and
the message below will appear. Press and
follow the directions below to rethread the lower
threading. If very little sewing remains, you can
embroider 10 final stitches without rethreading the
machine by pressing . The machine will
stop after sewing the 10 stitches.
a
Press .
→ After the thread is automatically cut, the carriage
will move.
b
Unlock the frame-securing lever and
remove the embroidery frame.
* Be careful not to apply strong force to the fabric at
this time. Otherwise, the fabric may loosen in the
frame.
c
Insert a wound bobbin into the machine.
(See page 26 for Setting the bobbin.)
d
Press .
→ The carriage will return to its original position.
e
Attach the embroidery frame.
f
To return to the spot in the pattern where
you stopped sewing, follow steps
c
through
f in the next section.
Note
• Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the
embroidery frame. Otherwise, the pattern will not embroider correctly.