Filter
Top Products
8
Express® Lavatory System SS-Series
SS-2/IR/STD, SS-2/IR/JUV Installation Instructions - For Service Only
5/11/04 Bradley Corporation • 215-1243 Rev. D; EN 03-813
Installation Instructions
continued . . .
Step 2: Mounting frame to wall
1. Remove the eight Torx-head screws securing the panel to the frame, and remove the panel
(see Figure 3).
Note: Scuff panel does not need to be removed.
2. Position the frame against the wall, ensuring that it is level. If necessary, insert shims under
the frame until level.
Note: When mounted, the Standard and Juvenile Height frames should rest on the floor.
IMPORTANT: Anchoring the frame to a wall that is
not
flat may cause the frame
to bend. If necessary, install shims to compensate for any wall
distortion.
3. Ensure that the back of the frame is flat against the wall. If wall is not flat, insert shims
behind the frame to ensure that it will not bend when anchored.
4. Once you have positioned the frame such that it is level and resting on the floor, and flat
against the wall or shimmed, use four 3/8" bolts and washers to mount the frame to the wall
(see Figure 4).
Figure 4
(4) 3/8" BOLT
AND WASHER
FRAME
Figure 3
PANEL
FRAME
(8) TORX-HEAD
SCREW
SCUFF
PANEL
(do not
remove)