Filter
Top Products
24
Installation (Vent-Air Intake System Installation) continued-
12. Mark the mounting screw hole locations for the backing plate. Rotate the
backing plate in order to gain access to the markings. With a 3/16 inch
diameter drill bit (not supplied), drill holes for the supplied wall anchors.
Install the wall anchors and secure the backing plate to the wall with
four (4) #10 x 1 inch screws (supplied) (See Figure 15). Note: Certain
construction of walls may require the use of a different type of anchoring
means than supplied.
Figure 15
IMPORTANT
When the installation is complete, visually inspect the air intake
system to insure that all joints are completely sealed.
INTERNET VERSION FOR REFERENCE ONLY