Filter
Top Products
EN
|
7
Bosch Security Systems | 18 August 2005
LTC 8016/90 | Instruction Manual | Unpacking
1.0 UNPACKING
This equipment should be unpacked and handled with
care. If an item appears to have been damaged in
shipment, notify the shipper.
Verify that all parts shown in the Parts List have been
included. If any items are missing, notify your Bosch
Security Systems Sales or Customer Service
Representative.
The original packing carton is the safest container in
which to transport the unit. Save it for possible future
use.
1.1 Parts List
2.0 SERVICE
If the unit needs repair, contact the nearest Bosch
Security Systems Service Center for authorization to
return and shipping instructions.
Service Centers
USA
Phone: 800-366-2283 or 717-735-6638
Fax: 800-366-1329 or 717-735-6639
CCTV Spare Parts
Phone: 800-894-5215 or 408-956-3853 or 3854
Fax: 408-957-3198
E-mail: BoschCCTVparts@ca.slr.com
Canada
Phone: 514-738-2434
Europe, Middle East & Asia Pacific Region
Phone: 32-1-440-0711
For additional information, see
www
.boschsecurity.com.
3.0 DESCRIPTION
3.1 General
The LTC 8016 Allegiant Bilinx Data Interface Unit
is an accessory device used to provide two-way
communication between a controller and up to
16 Bilinx-capable cameras. Full control of
pan/tilt/zoom functions and processing of camera
alarm/events are supported. The Interface unit is
especially suited for use with the Allegiant Series
Matrix Switcher/Controllers.
When connected to a head-end device generating
biphase control code, single direction communication
is available for control of pan/tilt/zoom, auxiliaries
and pre-positions of Bilinx- compatible cameras.
Camera setup is simplified when the Interface Unit is
used with the AutoDome Series of P/T/Z cameras,
since programming of the dome camera address is no
longer required. In addition to conventional CCTV
coax, configuration solutions are available for other
compatible video/data transmission products, such as
unshielded twisted pair (UTP) products and fiber
optic links.
3.2 Power
Model Rated Voltage Nominal
No. Voltage Range Power
LTC 8016/90 120 /230 VAC, 105 to 253 15 W
50/60 Hz
3.3
Compatibility Information
Although any device generating a standard video signal
can be connected to the Allegiant Bilinx Data Interface
Unit, it is only capable of communicating with devices
that are compatible with Bilinx technology.
If the unit is being connected to any of the following
devices, they must meet the following minimum
specifications:
• Allegiant Series Switcher/Controller
firmware 8.6 (released May, 2004) or later is
required if using the Allegiant data interface
connection.
• AutoDome Series Camera models with
firmware 5.11 (released October, 2003)
or later is required.
• Dinion Series Cameras that were manufactured
after March 2004.
Qty Item
1 LTC 8016/90 16-channel data interface unit
2 AC power cords (one for 120 VAC, and one for
220 - 240 VAC)
1 2 m (6 ft) 16-Conductor video ribbon cable
1 3 m (10 ft) Data interface cable
1 6-Position terminal block with 100Ω terminating resistor
2 Rack-mount brackets
1 Offset screwdriver (star & slot ends)
1 This installation manual