Filter
Top Products
EN
|
41
Bosch Security Systems | 20 January 2004
DVAS | Instruction Manual | Firmware Update
3. The download process includes storing the data
on the DVAS Series disk array, and will take
five to ten minutes. When the update has
finished, a message Transfer OK. firmware update
successful should appear.
4. Confirm that the update has succeeded by
entering the Web Monitor, and selecting the
Event Log page in user mode. The message,
Microcode Updated OK should be visible near the
top of the log.
5. The new firmware will take effect at the next
DVAS Series disk array power up.
Windows 98 timeout
If this procedure is followed on Windows 98 systems
(and possibly other systems), the FTP process in
Windows 98 will time out during Step 3. This occurs
after all data has been transferred to the DVAS Series
disk array, but before the storage process (flash update)
is complete. In this case, the Transfer OK message will
not appear, although the download should have
completed successfully.
After at least five minutes from the start of Step 2,
check the log to ensure that the update has been
successful. If so, the update will take effect at the next
restart (Step 5).