Filter
Top Products
EN
|
31
Bosch Security Systems | 20 January 2004
DVAS | Instruction Manual | System Menu
9SYSTEM MENU
The System Menu page permits access to the pages that
define the DVAS Series disk array connection to the
network.
9.1 SCSI Settings
Quick Configuration automatically configures these
settings.
Refer to the applicable DVR manual for
recommended SCSI settings.
Use this page to alter the behavior of the SCSI Host
Channels.
SCSI ID
Allows alteration of the SCSI ID of the DVAS array.
For most operating systems, the default SCSI ID of
0 is fine. All SCSI IDs on a bus must be different, so
ensure that the selected ID does not conflict with
another device ID on the bus. Use the pull down
menu to choose the desired ID.
Termination
By default, termination is set to AUTOMATIC, to
automatically determine whether termination is
required.
SCSI Max Transfer Rate
Defines the maximum speed of the SCSI bus. The
default setting is Ultra2. Click Save Settings to save
these settings.
To apply the new Network and SCSI setting, cycle
power to the unit.
9.2 Network Settings
The Net Settings tab permits alteration of the properties
of the DVAS Series disk array’s network connection.
Enter any new settings into the text boxes on the right-
hand side of the page, then click Save Configuration
to apply them.
How to Set IP Address
Use the radio buttons to select either DHCP (Dynamic
Host Configuration Protocol), or to manually set IP
address. If DHCP is chosen, no further values are required.
IP Address
If manually setting up the network, enter a free IP
address into the text box. The current IP address may
be acceptable.
Subnet Mask
Set the subnet mask that fits your network class. In
most cases, 255.255.255.0 is fine. Enter the new subnet
mask into the text box.
Gateway
Enter the IP address of your Internet gateway into this
text box.
Primary/Secondary DNS
Enter the IP address of both your Primary and
Secondary DNS into the text boxes.
Web Page Auto Refresh
Identifies whether the web pages should be reloaded
at a selected interval to show any system changes on-
screen. Check Enabled to use this function and specify
a value (in seconds) for frequency of web page
refreshing.
When all settings have been updated, click Save
Configuration. Restart the system so the changes take
effect.
Figure 38 Configuring SCSI
Figure 39 Configuring Network Settings