Filter
Top Products
EN
|
36
Bosch Security Systems | 20 January 2004
DVAS | Instruction Manual | Additional Information
11 Additional Information
11.1 Required Components
• (1) Slide Kit and Mounting Hardware
• (1) Pair Accuride Slide Rails
11.2 Rail Kit Installation
Step 1. Remove inner slide rail as shown in
FIGURE 46. Press down on latch to release.
Step 2. Attach inner slide rail to chassis using
3 x 8300047 M4 screws, as shown in
FIGURE 47.
NOTE: When attaching the extended brackets, first
attach them loosely. Adjust the length to fit the cabinet,
and then tighten.
Step 3. Attach left and right rear (long) extended
brackets to the outer rail using 2 x 8300045
M4 screws, 2 x 8300045 washers, and
2 x 8300044 nuts for each bracket
(FIGURE 48).
NOTE: Make sure the flange is on the bottom edge.
Step 4. Attach left and right front (short) extended
brackets to the outer rail using 2 x 8300045
M4 screws, 2 x 8300045 washers , and
2 x 8300044 nuts for each bracket
(FIGURE 49).
NOTE: Make sure the flange is on the bottom edge.
Step 5. Attach outer rail to chassis using 4 x M6 x 12
screws and cage nuts per rail, 2 at each end.
Step 6. Slide chassis into outer rail, carefully making
sure the chassis is level with the slide as in
FIGURE 50 (it’s easier if the drives and
power supplies are removed).
Figure 46 Remove Slide Rail
Figure 47 Attach Rail to Chassis
Figure 48 Attach (Long) Extended Brackets
Figure 49 Attach (Short) Extended Brackets
Figure 50 Attach Outer Rail and Slide Chassis in