Filter
Top Products
9
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Operation
Empty dirty container
Empty the dirt container as soon as the dirt reaches
the “full” line on the side of the container.
1. Unplug the vacuum from electrical outlet.
2. Slide the Lock ‘n Seal to the “Unlock” position.
3. Grasp the handle and pull the dirt container
straight out to remove from the vacuum.
4. Empty dirt into garbage container.
NOTE: Emptying the dirt container after
every use will help prevent over filling and
ensure that the vacuum is ready to go the
next time you clean.
Cleaning the dirt container
Additional steps can be taken to clean the
dirt container as necessary.
1.
Ensure dirt container has been emptied.
2. While the dirt container is still out of the unit,
grasp the inner cyclone screen and twist to
the right until the locking tabs stop the
rotation. Pull down the inner cyclone screen
to remove it.
3. Clean the inner cyclone with a cloth or soft
brush to remove dust or debris.
4. Wipe out the inside of the upper tank and
the inner cyclone with a damp cloth moist-
ened with water or a mild cleaning solution.
Let completely dry before next use.
5. If desired, the lower dirt container may be
washed in warm water. Make sure it is
completely dry before reassembling. Do not
put in the dishwasher.
6. To reassemble, replace the inner cyclone
screen by sliding it into the upper tank and
rotating it to the left until the locking tabs
stop the rotation. The inner cyclone screen
is labeled front and back. When properly
assembled the front graphic should face out.
WARNING:
To reduce the risk of
electric shock, turn
power switch OFF and
disconnect polarized plug
from electrical outlet
before performing
maintenance or
troubleshooting checks.
2 4