Filter
Top Products
14
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Replace drive belt
1. Unplug the vacuum from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1 – 4 of check
rotating floor brush and drive belt pg. 13),
grasp old drive belt and remove from motor
pulley. Discard the old drive belt.
3. Place one end of the new drive belt over
motor pulley and the other end over the
brush in the space between the bristles.
Note: It is important that you use
only genuine BISSELL replacement
parts. Generic belts may not meet the
exact specifications required to keep
your vacuum operating at its peak
performance. The use of unbranded
belts could lead to early failure of the
vacuum and could void your warranty.
4.
Pull the brush firmly to stretch the drive belt
and place ends of brush down into slots on
sides. Turn brush several times by hand to
center the drive belt.
5. Reposition brush cover and screws. Tighten
screws securely.
Brush reset
If something becomes lodged in the
foot and the brush shuts off, turn the
cleaner off and unplug from the outlet.
Remove the obstruction. The brush will
automatically reset when the cleaner is
plugged in and turned back on.
Maintenance and care
2
3