Filter
Top Products
15
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Changing the light bulb
1. Turn power switch off.
2. Unplug cleaner from electrical outlet.
3. Recline handle for easier access to light
bulb. Using a screwdriver or coin, gently pry
lens cover from foot.
4. Remove the bulb from the socket by
grasping the bulb and pulling gently. Install
the new bulb by pushing it gently into the
socket until the bulb snaps into place.
5. Reposition the lens over headlight by first
inserting tab on lower portion of the cover
into the vacuum foot. Push gently on cover
to lock tabs into place.
TurboBrush maintenance
The TurboBrush should be checked
regularly for clogs or debris wrapping
around the brush.
1.
Remove tool from hose or from vacuum.
2. Twist collar so opening is at the top and lift
top cover to remove.
3. Remove the brush from the belt and clean
debris.
4. Replace the brush inside the belt and place
ends into slots on sides.
5. Reposition top cover making sure to line up
inside tab at the front with the opening on
the cover. Twist collar until opening is at the
bottom to lock into place.
Maintenance and care
3
4
2.
4.
5.
Tip:
TurboBrush may not be turning due
to loss of suction. Refer to pg. 12 for
checking and cleaning clogs.