Filter
Top Products
16
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
7
Brush Switch
The rotating brush is turned on or off using the
switch located next to the power switch on the
top of the tank. When the brush switch is on, the
brush will start rotating when the unit is reclined.
The brush should be on for most carpeted floors.
You may want to turn the brush off for bare floor
cleaning or other delicate surfaces.
Push the rocker switch “ON” (I) to turn the brush
on, and “OFF” (O) to turn brush off.
Height Adjustments
There are seven height settings available for
various floor surfaces. Turn the dial on the foot of
the cleaner to the desired setting.
Lowest setting – for low pile carpet or bare
floors. To pick up debris it may be necessary
to move up one setting.
Medium settings – for medium pile carpet.
High setting – for high pile and most shag carpet.
Note: For optimal carpet cleaning
performance, adjust to the lowest practical
setting. If your cleaner is difficult to push,
adjust to the next higher setting.
If the dial is difficult to turn, tilt the cleaner
back slightly to take the weight off of the foot
while turning.
*Some Berber carpets have a tendency to fuzz
with wear. Repeated strokes in the same area
may aggravate this condition. Consider setting
your cleaner on a higher than normal setting for
this type of carpet.
Brush Auto Shut Off Feature
When your cleaner is in the upright posi-
tion, the brush will not rotate. The brush
will rotate only when the cleaner is in the
relined position and the brush switch is on.
Operation
NOTICE:
While vacuuming, certain carpets
and low humidity conditions may
generate small static discharges. The
discharges are entirely harmless and
are not associated in any way with
the main power supply.
Brush Switch
Tip:
Check under furniture for
objects that could damage
or block the hose.