Filter
Top Products
13
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
Check rotating floor brush and drive belt
You should check your vacuum cleaner’s
rotating floor brush and drive belt regularly
for wear and damage. You should also clean
the brush and brush ends of strings, hair,
and carpet fibers. This type of debris can
wrap around the brush and hamper its
ability to effectively clean your carpet. Also
remove any debris that has accumulated
under the brush cover.
1.
Unplug the vacuum from electrical outlet.
2. Place handle in low position and turn vacu-
um cleaner over so bottom side is facing up.
3. Remove the six screws on the sole plate
with a Phillips head screwdriver. Lift the
brush cover off.
4. Grasp rotating floor brush at both ends and
lift.
5. Clean string, hair, and other debris from
rotating floor brush, paying particular atten-
tion to brush ends.
6. Check air passageway for obstructions.
Remove any debris from this area.
7. Clean debris from the motor pulley and drive
belt areas.
8. Check drive belt carefully for wear, cuts, or
stressed areas. If any damage is present,
discard old drive belt and replace.
Maintenance and care
3
4