Beckett CF3500 Burner User Manual


 
6104 BCF35 R11 Page 3
Hazard De nitions
Owner’s Responsibility:
Service Agency Responsibility:
Section: General Information
Indicates a hazardous
situation which, if not
avoided, will result in death or serious injury.
Used with the safety
alert symbol, indicates a
hazardous situation, which, if not avoided,
may result in minor or moderate injury.
Indicates a hazardous
situation, which, if not
avoided, could result in death, or serious
injury.
Used to address practices not
related to personal injury.
General Information
50 Hz Motors - The burner ratings,
air settings and nozzle ratings are
based on standard 60 Hz motors (at 3450 rpm). Derate
all ratings 20% when using 50 Hz motors. Consult
factory for speci c application data.
Follow these instructions
exactly.
Failure to follow these instructions, misuse, or incorrect
adjustment of the burner could result in asphyxiation,
explosion or re.
Contact a professional, quali ed service agency for the
installation, adjustment and service of your oil burning
system. Thereafter, have your equipment adjusted and
inspected at least annually to ensure reliable operation.
This work requires technical training, trade experience,
licensing or certi cation in some states and the proper
use of special combustion test instruments.
Never store or use gasoline or other ammable liquids or
vapors near this burner or appliance.
Never attempt to burn garbage or refuse in this appliance.
Never attempt to light the burner by throwing burning material
into the appliance.
Never attempt to burn any fuel not speci ed and approved for
use in this burner.
Never restrict the air inlet openings to the burner or the
combustion air ventilation openings in the room.
y
y
y
y
y
Frozen Plumbing and
Water Damage Hazard
If the facility is unattended in severely cold weather,
burner primary control safety lockout, heating system
component failures, power outages or other electrical
system failures could result in frozen plumbing and
water damage in a matter of hours. For protection, take
preventive actions such as having a security system
installed that operates during power outages, senses low
temperature and initiates an effective action. Consult with
your heating contractor or security agency.
Follow these instructions
exactly.
Failure to follow these instructions could result in
asphyxiation, explosion or re.
Please read all instructions before proceeding. Follow
all instructions completely.
This equipment must be installed, adjusted and started
by a quali ed service agency that is licensed and
experienced with all applicable codes and ordinances
and responsible for the installation and commission of
the equipment.
The installation must comply with all local codes and
ordinances having jurisdiction and the latest editions of
the NFPA 31 and CSA-B139 & B140 in Canada.
y
y
y
High altitude installation - Accepted
industry practice requires no derate
of burner capacity up to 2000 feet above sea level. For
altitudes higher than 2000 feet, derate burner capacity
2% for each 1000 feet above sea level.
Speci cations
Fuels
U.S. #1 or #2 heating oil only (ASTM D396)
Canada #1 stove oil or #2 furnace oil only
DO NOT USE
GASOLINE,
CRANKCASE OIL, OR ANY OIL
CONTAINING GASOLINE.
Firing Range CF2500A - 17.0 to 19.9 gph
CF2500 - 17.0 to 25.0 gph
CF3500A - 17.0 to 35.0 gph
Motor 2 HP 3450 rpm
208/230/60 Hz Standard
13.4 amps @ 230 VAC
Optional Voltages:
208, 230, 480, 575 VAC/3-PH,
50 or 60 Hz
Ignition Trans. Continuous Duty, 120V/12,000V
Housing Cast aluminum
Fuel Unit 100 to 300 psig
Oil Nozzle 45
o
to 70
o
Solid
Dimensions Refer to Figure 8.