Filter
Top Products
16 Encore VPx Installation Guide • 08-0311105-00 Rev 00
båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
Installation
• Distribute the units evenly to prevent hazardous conditions that may be created by
uneven weight distribution.
• Rack mount the units from the front rack ears using four rack screws (not
supplied). Threads may be metric or otherwise — depending upon the rack type.
• Install the lower of the two mounting holes first.
fåëí~ääáåÖ=smñ
This section provides detailed VPx installation procedures for the Encore configurations
listed below. Select the desired configuration, and follow all steps.
The following installation procedures are provided:
• Installing VPX in a Wide Screen Configuration
• Installing VPx in a Wide Screen Preview Configuration
• Installing VPx in a Wide Screen Stack Configuration
Important
Only valid VPx configuration procedures are included below.
Note that steps for connecting peripherals (e.g., ScreenPRO-
II, Aux destinations, routers, tally, D/As, etc.) in a system are
not covered below, but are fully covered in Chapter 3 of the
Encore Presentation System User’s Guide.
Important
Software version 1.22 (or higher) must be installed first in
your Encore Controller, prior to connecting your VPx
processor(s). Refer to Appendix C, “Upgrading Software”
in the Encore Presentation System User’s Guide for
complete upgrade instructions.