Filter
Top Products
Optional Equipment (for qualified installers only) 37
© Travis Industries 4060111 100-01175
LP Conversion Instructions
Install the conversion kit prior to installing the gas line to ensure proper gas use.
1 Remove the glass (see page 21). Remove the logs and coals (if installed - page 23)
2 Remove the burner (see illustration below).
WARNING: Do not disassemble the burner – screws on the burner must be left in place.
WARNING:
The burner is fragile -
handle it with care.
Remove the
firebox floor.
Lift the pilot hood off
the pilot assembly
(you may need to pull
hard to remove).
a
b
d
Lift the left side of the burner slightly, then slide it to
the left and lift it upwards (lift the burner from below).
c
Pull the burner forward, out
of the firebox.
NOTE:
Make sure the burner
is fully seated. When
in place, the pilot
flame must align
directly above the
burner holes.
Slide the air shutter
all the way to the
right before
installing the burner.
Make sure the mixing tube
slides onto the orifice.
Make sure the bolt head on
the bottom of the burner
inserts into this hole.
Mixing Tube
Orifice
Replace the pilot hood
after replacing the burner.
Burner Replacement:
Make sure the burner is fully
seated. When in place, the pilot
flame must align directly above the
burner holes.