Filter
Top Products
26 Finalizing the Installation
© Travis Industries 4060111 100-01175
FINE TUNING THE EMBER-FYRE™ BURNER
Each installation is affected by altitude, vent configuration, and fuel quality. Because of this, the
restrictor and air shutter may need to be fine tuned to each installation. Follow the hints below to fine-
tune the burner for optimum performance and aesthetics.
Restrictor Adjustment:
Only those installations determined to be over-drafting require this adjustment. See the instructions on
page 15 for details.
Air Shutter Hints:
• For more glow, open the air shutter, however, this will make the flames more blue.
• For yellow flames, close the air shutter, however, this may create less glow.
The flames should burn right
off the top of the burner ports
(if they are too blue, adjust
the air control).
Lifting flames indicate
insufficient draft (restrictor
is set too high).
Burner
Burner Ports
(holes)
Ghosting flames indicate
insufficient air (restrictor set too
high, air shutter shut down, or
other venting error).
Lifting FlamesCorrect Flames Ghosting Flames Flickering Flames
Flickering, short flames
indicate excessive draft
(move air shutter to a higher
position).
Warning: If the vent configuration is installed incorrectly the vent may cause the flames inside the heater to
lift or “ghost” – a dangerous situation. Inspect the flames after installation to insure proper
performance. If the vent confi
g
uration is correct,
y
et the flames are liftin
g
or
g
hostin
g
, shut off
g
as
to the heater and contact the dealer for information on remedying the problem.
8. Replace the glass.
9. Attach the face following the directions included with the face.
NOTE: If using a Rosario or Discovery face you may wish to modify the face connector (see
page 11 for details).
NOTE: If using the Arched, Artisan, Metropolitan, or Victorian Lace Face you must use the face
mounting brackets included with the heater (see page 12 for details).
10. Turn the flame adjust knob to its highest position - the flames should not contact the top of the
firebox. Check the flame on low position. The flames should burn off of each burner hole. If
the heater does not work correctly, contact your dealer for a remedy.
11. Give this manual to the home owner and fully explain the operation of this heater.