Filter
Top Products
Installation (for qualified installers only) 19
© Travis Industries 4060111 100-01175
Surround Panel Installation
PANEL SIZE WIDTH HEIGHT PART #
8" x 10" Rectangular 40-3/8" 28-7/8" 98500610
Arched (8” x 10”) 40-3/8" 28-7/8" 98500622
10” x 13” Rectangular 44-3/8" 31-7/8" 98500611
1 Follow the directions below to install the side panels.
NOTE:
These 3/8" stand-offs are not required
and may be flattened (both sides).
Line up each side surround
panel and insert two screws from
the outside to secure in place.
5/16" Nutdriver
Pre-thread the holes on the surround
panels with the screws included in the
surround panel kit.
b
a
Run the rheostat wires,
on/off switch wires, and
power cord through the
access hole on the insert
2 Follow the directions below to install the top panel.
Install the top panel so the
two tabs insert into the slots
on the side panels.
Top
Panel
Top Trim
"L" Bracket
Right Side Trim
Construct the panel trim. Insert one leg of each "L"
bracket into the top and side trim piece. Align the
trim to form a precise corner, then tighten the two set
screws with a small standard screwdriver. Slide the
trim over the panels.
Tighten the set
screws from the back
side with a small
standard screwdriver
"L" Bracket
Right Side
Trim
Top Trim
b
Slot for on/off
switch and hole
for rheostat
NOTE:
These 3/8"
stand-offs are
not required
and may be
flattened.
The insulation included with the
panels may be discarded.
a