Filter
Top Products
Operation 27
© Travis Industries 4060111 100-01175
Before You Begin
• Read this entire manual before you use your new heater (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage,
bodily injury, or even death.
Location of Controls
Open the
access door
to view the
controls.
Gas Control Valve
Gas Control Knob
Flame Adjust Knob
An instruction card for
operating the fireplace is
attached to the inside of the
fireplace here. Replace it for
easy reference.
PILOT
IGNITER
LO
OFF
HI
O
F
O
N
F
ON/OFF Switch is
located either on
the upper right of
the surround panels
or behind the
access panel
The Pilot Flame can be
found below the back log.
Blower Knob is located either on the upper
right of the surround panels or behind the
access panel
Blower Knob This knob controls the speed of the internal convection blower that
pushes the heated air into the room.
On/Off Switch This control is used to turn the heater on and off.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark
directly next to the pilot, igniting the pilot flame.
Gas Control Knob This knob is used to control gas to the heater and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of
the knob indicates the position this knob is in.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The
pointer above the knob points to the position this knob is in.