Filter
Top Products
38 Safety Label
Travis Industries 4050225 100-01154
WARNING - DO NOT REMOVE OR COVER THIS LABEL
Listed Pelletized
Solid Fuel Burning Appliance
Also for Use in Mobile Homes
Model: Astoria PS
Serial No:
Tested to: ASTM E, 1509-95, Room Heater Pellet Burning Type (UM) 84 HUD
Electrical Rating: 115V, 60Hz, 3 Amp; Start 3 Amps, Run 1.5 Amps
Maximum Input Rating: 5.5 lbs (2.5kg)/hr
This pellet fired appliance has been tested and listed for use in manufactured (mobile) homes in accordance
with OAR 814-23-900 through 814-23-909.
WARNING - FOR MANUFACTURED HOMES: Do not install appliance in a sleeping room. Must utilize outside
combustion air inlet (part #99200136) or equivalent. Structural integrity of the manufactured home floor,
ceiling, and walls must be maintained.
Install only in accordance with the manufacturer’s installation and operating instructions. Contact local
building or fire officials about restrictions and installation inspection in your area.
Use only listed 4 in./100 mm diameter listed type “L” or “PL” venting system. See manufacturer’s installation
instructions and local codes for precautions required for passing chimney through a combustible wall or
ceiling. Do not connect this appliance to a vent serving another appliance. Inspect and clean exhaust venting
system frequently in accordance with manufacturer’s instructions.
May be installed in a sleeping room with use of outside combustion air inlet (Part #99200136) or equivalent.
Minimum Clearance to Combustible Materials (Measured to Stove Top)
BACKWALL
LEFT SIDEWALL
FLOOR PROTECTOR
A
C
HH
B
G
E
ADJACENT WALL
ADJACENT WALL
D
D
RIGHT SIDEWALL
E
Interior Vertical Horizontal Through
Flue Installation the Wall Installation
Left Sidewall A 9” 9”
Right Sidewall B 9” 9”
Backwall C ** 3”
Corner D 3” 3”
Flue Vent E 3” 3”
Maximum alcove depth 48 in/1220 mm, minimum ceiling height 60 in/1525 mm, minimum alcove width
46 in/1165 mm.
Combustible floor must be protected by a non-combustible material, extending to the front (G) 6 in/150 mm
and to the sides (H) 0 in/0 mm.
EXCEPTIONS: Non-combustible floor protection must extend beneath a vent tee when installed.
** This dimension will vary depending on brand of listed type “L” vent. See manual for details.
For use with 1/4 in/6 mm to 5/16 in/7 mm diameter pelletized wood fuels only.
Replace glass only with 5 mm ceramic glass available from your dealer.
DANGER: Risk of electrical shock. Disconnect power supply before servicing. Route power cord away from
unit. Do not route power cord beneath heater.
Operate only with viewing door and ash removal tray tightly closed. Do not obstruct combustion air openings.
The space beneath heater must not be obstructed. Keep all furnishings away from heater.
U.S. ENVIRONMENTAL PROTECTION AGENCY
This model is exempt from EPAcertification under 40 CFR 60.531 by definition
[Wood Heater (A) “Air-to-fuel Ratio”].
Date of Manufacture
2001 2002 2003 Jan Feb Mar Apr May Jun Jul Aug Sep Oct Nov Dec
DO NOT REMOVE THIS LABEL MADE IN U.S.A.
Mfg. by TRAVIS INDUSTRIES, INC.
10850 117th Pl N.E.
Kirkland, WA 98033
Report No. 028-S-42-2
0406