Filter
Top Products
EConnect™ TA7210
7
Start wireless setup
Press the EIM Connect button to place it in wireless setup. When the amber light changes
to a green flashing light, you can begin to link devices to the wireless network (see pages
7-10).
Install batteries in wireless devices
3.
Thermostat Remote control
(optional)
Outdoor air sensor
(optional)
Install 2 AA alkaline batteries Install 3 AA alkaline batteries Install 2 AA lithium batteries
Link all devices to wireless network
4.
If the amber light changes to a red light
instead, there is another EIM currently in
wireless setup. Press the Connect button
on the other EIM to exit its wireless setup.
If the green flashing light disappears (after
a delay of 15 minutes) before you have
time to link all your devices, press the
Connect button again.
Connect button
* Flashing green: Ready for connection
Steady green: Connection established
Steady red: Connection failure
Connect LED *
69-2472EF-01 (Aube TA7210 System Installation Guide).book Page 7 Wednesday, June 29, 2011 1:15 PM