Ariens 915057 Air Cleaner User Manual


 
5 - 17
7. Remove fuel line from engine first. Drain fuel from
line back into fuel tank.
8. Remove the electric clutch and the anti-rotation
bolt.
9. Remove the engine bolts.
10.Lift engine out of the unit and off the frame with a
hoist (engine).
11.Service, overhaul, or replace engine as required.
12.If replacing engine with a new engine, the following
items will have to be removed (if used) from the old
engine. These items will not be included with a new
engine:
Engine sheave and key
Mounting hardware
Engine wiring harness.
5.10 ENGINE INSTALLATION
1. Check the engine base and unit frame for damage
before installing the engine.
2. Place the throttle and choke controls, fuel line, and
electrical wires out of the way prior to installing the
engine.
3. Once the engine is bolted onto the frame, install
the exhaust system and then tighten the mounting
hardware.
4. Install the engine sheave, belts, springs, electrical
wiring, throttle, and choke controls.
5. Install the negative battery cable onto the battery.
6. Install the fuel line.
7. Fill engine with 10-30 above 32°F (0°C) or 5W30
below 32°F (0°C).
8. Install the engine cover, then test operation and
function of the engine.
9. Check the fluid levels as follows:
a) Start the engine and allow it to reach to
operating temperature. DO NOT operate
engine for more than two minutes.
b) Shut the engine off, wait for engine to cool, and
be sure the engine oil level is between the full
and add marks on the dipstick. If it is below the
add mark, add recommended oil. DO NOT
overfill.
WARNING: AVOID EXHAUST FUMES! DO
NOT run engine in an enclosed area.
ALWAYS provide good ventilation and wait
until hazard has been removed.