Filter
Top Products
PERIMETR PART ?
COMMAND 8
Partially Turn On the Perimeter
Description
This function is used to turn on the perimeter of your
building while selected portions of the perimeter
remain turned off. Perimeter points that are not secure
(faulted) when this function is entered are
automatically bypassed and are not included in the
system. This function does not turn on the interior of
your building. Entry/exit delays are provided with this
arming command.
Use this function in residential systems to turn on the
front of your house while the interior and the rear
perimeter doors are left turned off, giving you freedom
of movement between the house and patio.
In commercial systems, when you need access to the
large overhead doors to receive deliveries, using this
function will allow you to keep the rest of the building
perimeter armed.
8
Using Perimetr Part:
1. Ensure that the command center shows disarmed
idle text. Before using this function, decide which
points are to be left turned off. Fault the points
(doors and windows) by leaving them open. The
points must remain open until after the exit delay
time expires.
2. Press the COMMAND bar. The display shows
SYSTEM COMMAND.
3. Press the 8 key.
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function. Press
the MENU key to enter the Command Menu, then
press NEXT repeatedly until you reach the
PERIMETR PART ? prompt. Press ENT.
4. The display shows EXIT NOW #. When exit
delay time expires and the system turns on, the
display shortens to PERIMETR PARTIAL.