Filter
Top Products
47
3. Press the 4 key followed by the 7 key.
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function. Press
the MENU key to enter the Command Menu, then
press NEXT repeatedly until you reach the RESET
SENSORS ? prompt. Press ENT.
4. The display shows SENSORS RESETING for
approximately 3 seconds and then goes blank
before returning to idle disarmed text.
If you enter this function and the detector or sensor
resets momentarily, but then returns to a faulted
condition, the conditions causing the activation may
still be present or the detector may be faulty. Check to
be certain that there is no smoke, fire, or other danger
present.
If you can’t reset the detector or sensor contact your
security company.
RESET SENSORS ?
COMMAND 47
Reset Sensors
Description
Detection devices, such as smoke detectors and shock
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them. It also clears point information
from the display, leaving the ALARM SILENCED
message in the display as a reminder that the View
Memory function can be used to view the cleared
point information. Entering a valid passcode and then
pressing the ESC key clears the ALARM SILENCED
message and the event memory. Arming the system
will also clear the display and the event memory.
Using Reset Sensors:
1. Ensure that your command center is at idle
disarmed text.
2. Press the COMMAND bar. The display shows
SYSTEM COMMAND.