Filter
Top Products
PERIMETR INST ?
COMMAND 2
Turn On the Perimeter With No Delays
Description
Use this function to turn on only the perimeter of your
building, leaving the interior of the building disarmed.
This function allows no exit or entry delay time through
the perimeter, including the designated exit delay door.
This function is useful in residential systems when
everyone is home and ready to retire for the evening.
You can have the security of an armed perimeter, yet
move freely throughout the interior of the premises.
It is also useful in commercial systems when you are
working before or after business hours and wish to have
the perimeter armed. Remember there are no entry or
exit delays when you use this function. You must
disarm (turn off) the system to enter or exit the
premises.
2
Using Perimetr Inst:
1. Interior points are not armed with this command
and may remain faulted while arming with
COMMAND 2.
2. Press the COMMAND bar. The display shows
SYSTEM COMMAND.
3. Press the 2 key.
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function. Press
the MENU key to enter the Command Menu, then press
NEXT repeatedly until you reach the PERIMETR
INST ? prompt. Press ENT.
4. The display shows PERIMETR INSTANT. After
arming the perimeter without delays, you cannot
enter or exit the premises without disarming the
system. Opening a perimeter door before disarming
will generate an alarm. If this happens, silence the
alarm by turning your system off and call your
security company to let them know that it is not an
emergency situation.