2.1.2 Switch Front Panel
Figure 2-1 shows the front panel of the switch.
Figure 2-1 WGSW-2620PV front panel.
2.1.3 LED Indications
Network/PoE:
LED Color Function
PWR Green Lights to indicate that the Switch is powered on.
PoE Green Lights to indicate the port is providing 48VDC in-line power.
LNK/ACT Green Lights to indicate the link through that port is successfully established.
FDX/COL Green Blink to indicate that the switch is actively sending or receiving data over that port.
Gigabit:
LED Color Function
LNK/ACT Green Lights to indicate the link through that port is successfully established.
FDX/COL Green Blink to indicate that the switch is actively sending or receiving data over that port.
2.1.4 Switch Rear Panel
Figure 2-2 shows the rear panel of the switch
Figure 2-2 WGSW-2620PV rear panel.
Power Notice:
1. The device is a power-required device, it means, it will not work till it is powered. If your networks
should active all the time, please consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also help to protect your switch from being
damaged by unregulated surge or current to the Switch or the power adapter.
2.2 Install the Switch
This section describes how to install the Ethernet Switch and make connections to it. Please read the
following topics and perform the procedures in the order being presented.
